There are many ways to install bearings, and the installation and disassembly methods vary depending on the type of bearing and the operating conditions. Huagang Bearing specializes in various types of precision bearings. Today, LIGZZ Bearing Editor will talk to you about the topic of bearing cold installation. I hope it can be helpful to you.

1. When installing small bearings that are not too tight, the bearings can be installed in the appropriate position by gently tapping the sleeve through a sleeve and using a hammer. When striking, it should be applied evenly on the bearing ring as much as possible to prevent the bearing from tilting or tilting. Using some specially designed impact rings can make this method easier to use. Li Gong bearing.

2. If the inner and outer rings of a non separable bearing are to be installed on both the shaft and the bearing seat simultaneously, it must be ensured that the same pressure is applied to both the inner and outer rings, and the contact surface between the installation tool and the bearing ring must be on the same plane. In this case, special bearing installation tools can be used to ensure that the pressure generated during striking simultaneously acts on the inner and outer rings of the bearing. Li Gong Bearing

When installing automatic self-aligning ball bearings, if the bearing needs to be installed into the bearing seat, some specially designed installation rings can be used to prevent the outer ring from tilting and swinging. The roller of partially sized automatic self-aligning ball bearings protrudes beyond the side of the bearing, so the design of the installation ring should avoid contact and damage to the roller. Most automatic self-aligning ball bearings are installed using mechanical or hydraulic methods. Li Gong Bearing

3. For separated bearings, as the inner and outer rings can be installed independently, the installation process is generally relatively simple. When installing the shaft and other components and inner ring into the outer ring of the bearing seat, it is necessary to ensure that the inner ring is aligned with the outer ring to avoid scratching the raceway and rolling element of the bearing. Li Gong Bearing

When installing cylindrical and needle roller bearings with or without retaining edges on one side of the inner ring, it is recommended to use some special installation sleeves. The outer diameter of the sleeve should be equivalent to the diameter of the inner ring raceway, and the tolerance standard should be d10. LIGZZ Li Gong Bearing

Li Gong Bearing looks forward to cooperating with you! Li Gong Bearing, website: www.ligzz.com